[. . . ] W10665256B RANGE SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING. [. . . ] Visually check that the rear range foot is inserted into the slot of the anti-tip bracket. Slide range into final location, making sure rear leveling leg slides into anti-tip bracket. Place the outside of your foot against the bottom front of the warming drawer or baking drawer to keep the range from moving, and grasp the back of the range as shown. Small cap Medium cap Large cap X-Large cap Burner caps should be level when properly positioned. If burner caps are not properly positioned, surface burners will not light. If you encounter immediate resistance, the range foot is engaged in the anti-tip bracket. 3 cm) off the floor without resistance, stop tilting the range and lower it gently back to the floor. IMPORTANT: If there is a snapping or popping sound when lifting the range, the range may not be fully engaged in the bracket. Check to see if there are obstructions keeping the range from sliding to the wall or keeping the range foot from sliding into the bracket. Verify that the bracket is held securely in place by the mounting screws. Slide the range forward, and verify that the anti-tip bracket is securely attached to the floor or wall. Slide range back so the rear range foot is inserted into the slot of the anti-tip bracket. Repeat steps 1 and 2 to ensure that the range foot is engaged in the anti-tip bracket. 3 cm) off the floor without resistance, the anti-tip bracket may not be installed correctly. Do not operate the range without anti-tip bracket installed and engaged. Please reference the “Warranty” section of the User Guide to contact service. IMPORTANT: If the range is moved to adjust the leveling legs, verify that the anti-tip bracket is engaged by repeating steps 1-8. The first time a burner is lit, it may take longer than 8 seconds to light because of air in the gas line. Check that the circuit breaker has not tripped or the household fuse has not blown. If the burner does not light at this point, press the off pad and contact your dealer or authorized service company for assistance. Please reference the “Warranty” section of the User Guide to contact service If the bake burner flame needs to be adjusted, see the “Adjust Flame Height” section. The first time a burner is lit, it may take longer than 8 seconds to light because of air in the gas line. [. . . ] Test the flame by turning the control from the low position to the high position, checking the flame at each setting. IMPORTANT: Make sure to save the orifices that have just been replaced in the conversion. Light burner and turn to lowest setting where both inner and outer burners are lit. Insert a ¹⁄₈" (3 mm) flat-blade screwdriver into the adjustment locations shown in the following illustration and engage the slotted screw. [. . . ]